Frequently Asked Questions (FAQ) home page

Below you'll find the most common asked questions about Grippex. If you have any questions about Grippex or our other products please contact us.


Q. Which pressure is required to pull the bar?

Very little coolant pressure is required to operate the 3-finger Grippex. As little as 1.0 P bar is enough to pull a bar weighting approx. 85 kg (at a coefficient of friction valued <0.2).
Q. How I get a trouble free pulling?

Spindle liners should be used in conjunction with the Grippex to keep the bar centralized. An unsupported bar is also subject to high frictional forces which could result in pulling difficulty. A poorly supported bar may whip insed a spindle, resulting in vibration and possible spindle damage.

Q. What will I do if our lathe's coolant system is quiped with non return valve?

Some lathes coolant systems are equiped with a check valve which prohibits coolant from flowing backward when it's turned off. This lead to that the gripping fingers aren't open so quickly. For avoid this has Grippex a bleed valve on the body which is opened with screwing some turns ccw.

Q. Are the Inserts hard enough? Is it easy to change them?

Grippex II provides inserts, which can comfortably be exchanged even with the Bar Puller already mounted on the turret. The Inserts are hardened to a degree of HRC57, which assures a long life of hard work.
To be fitted the inserts is placed with the radious of the gripping finger and turned until its tapped hole matches the through-hole fo the finger. Finally, the inserts is secured by the locking screw.

Q. What I do if our lathe has VDI50 revolver?

A lathe which has VDI50 is a big lathe and you can use a Standard Shank ø40 mm in combination with a VDI50 shank adapter without interference problems.

Q. What I do if I have a very small lathe?

Grippex II Small and Grippex II Mini are developed to be used in very small lathes.

Maskinportalen

for machine tool
industry.

- News
- Agent register
- Suppliers
- Links etc.


maskinportalen.se

Copyright © 2006 MPC Automation Systems AB